After an EtherChannel is configured between two Cisco switches, interface port channel 1 is in thedown/down state. Switch A is configured with channel-group 1 mode active, while Switch B isconfigured with channel-group 1 mode desirable. Why is the EtherChannel bundle not working?
A. The switches are using mismatched EtherChannel negotiation modes.
B. The switch ports are not configured in trunking mode.
C. LACP priority must be configured on both switches.
D. The channel group identifier must be different for Switch A and Switch B.
Answer: A
No comments:
Post a Comment
Note: only a member of this blog may post a comment.